Single-burner Gas Stove For Home Embedded/Table Type Gas Furnace Household Gas Cooker

1. Installation of gas stove
The installation of the stove is relatively simple. Check whether the gas type is appropriate. For embedded stoves, dig holes in strict accordance with the opening size given in the manual, and fix them with matching clips. It should be noted that the intake pipe must be fixed with a pipe clamp and the length should be appropriate. Too long will increase the resistance of the intake pipe and cause pressure drop and reduce the heat flow of the stove. The size of the hose should be matched with the joint. If it is loose, the seal will not be tight and cause air leakage. If it is too tight (for example, it can be covered with hot water), it will accelerate the aging of the hose. In addition, check the hose regularly for cracks and falling off. Because many fires caused by cooking appliances are caused by joints.

(1) Carefully read the instructions for use of burning appliances of the same brand. There may be differences in using methods. Please read carefully and use them correctly.

(2) At the end of gas use, pay attention to cultivating the good habit of extinguishing the fire. After use, before going to bed or when going out, check whether the gas has been turned off. Turning off the gas means: turn off the gas appliance switch cock and ball valve, usually close the gas appliance switch, gas cylinder gas valve, if you are away from home If the time is longer, the ball valve in front of the gas meter should be closed to completely cut off the gas source.

(3) During use, please be careful not to use burning appliances, soup, milk, pasta, etc. to overflow when cooking without being unattended. Be sure to take care of it to prevent overflowing soup from drenching the fire and causing gas leakage .

(4) Be careful when you can’t start a fire. If you can’t start a fire three times in a row, you should pause for a while and make sure that the gas has dissipated before starting the fire again; because although the burning appliance has not ignited, the gas has been released many times and it is very easy to encounter an open flame. When using a water heater, pay special attention to this problem.

(5) After turning on the burning appliance, pay attention to turning on the switch of the burning appliance. Make sure that the burning appliance is on fire before leaving. Because if the burning appliance fails, there is no fire, and the burning appliance switch is kept on, it will cause gas leakage.